Trough mixer possible malfunctions start host vibration host oil spill, etc.
Channel mixer for mixing the powder or paste materials, different materials, mixing. Horizontal channel a single oar mixed, the agitation paddle through shaft for easy cleaning. Contact with objects all made of stainless steel, good corrosion resistance, mixing tank automatically flips down material. The popular channel mixer with good dispersion, the use of a wide range of easy to use, long life, small investment, quick, on many occasions.
  But many channel mixer operator inexperience for their day-to-day maintenance and fault repair, so that small problems do not timely repair drag became a big failure, thus greatly shortening the life of the channel mixer. Below to give you a brief introduction channel mixer, common faults and solutions, as well as the day-to-day maintenance of the channel mixer method.
  Channel mixer may malfunction simple there are several, including start-up, host vibration host oil spills and so on.
  Startup difficulties and can not start, the cause of this phenomenon is generally attributed to the following three cases also include three corresponding solution:
  1, full load and overload start running solution: reduce the load, the first operation after feeding;
  2, the power is not connected to the lack of phase responses: access to power for an electrician check the line;
  3, the voltage is too low, Countermeasures: avoid the peak, or to ensure that the voltage is normal.
  Second, the small channel mixer host vibration and abnormal noise noise, including five kinds of incentives and five corresponding solutions for this phenomenon:
  1, damage to the propeller shaft, countermeasures: Replace the propeller shaft;
  Installation is not adjusted Countermeasures: Reinstall and adjust the mixer horizontal plane;
  3, spiral blades damaged Solution: Replace the spiral blades;
  4, gearbox damage responses: replacement of the damaged parts of the gearbox;
  5, no oil or lubrication pump oil Countermeasures: add oil or replace oil pump or clean up the oil pump pipe obstructions.
  Third, small Trough mixer cylinder body leakage phenomenon, mostly because of its seals, as follows:
  Viscous material into the seal, the solution is to clean the seals;
  Seals aging or damaged countermeasure is to replace the seals.
  Under normal circumstances, the above are the channel mixer problems encountered in the process, relatively speaking, according to the above can solve.
Related News:
· Innovation, energy saving, environmental protectio  
· Vacuum dryer product performance characteristics a  
· Vacuum dryer used for inspection and debugging wor  
· Difficulties and reasons cannot start mixing machi  
· The correct operation method using vacuum dryer  
· Development advantages and characteristics of dome  
· The difference between the special vacuum dryer an  
· Detailed description of each component characteris  
· The dominant position in the whole vacuum dryer dr  
· Trough type mixer sometimes appear large area leak  
Related Products:
· PGL Spray Drying Granulator
· High speed mixer
· SET series double screw extrusion pelletizer
· VI forced mixer
· Mixing machine W series
· Powder machine ZSJ series vibrating screen
· FZ series of crushing granulator
· Chinese medicine grinder
· DWT series of drier for dehydrated vegetables
· Multi-layer belt dryer

Copyright 2013 Chang Zhou Zhizun Machinery Co.,Ltd All Rights Reserved.Design by Reach.
Tel:86.519-88906508 Fox:86.519-88902679 Add:Jiaoxi Changzhou Jiangsu Pro China P.C:213116