Universal grinder safety in production before the preparation of the checks
Universal grinder usually prior to use, how to check?As follows:
  1, check the universal grinder bearing lubrication is good
  2, check the universal grinder all fasteners are tightened.
  3, check the universal grinder drive belt is installed correctly and in good condition, if the belt damaged should be replaced when the oil belt or sheave, apply a clean cloth wipe in a timely manner.
  4 is good, check the universal grinder protective devices, protective equipment, insecurity, should be immediately removed.
  5, check the universal grinder broken cavity whether the materials or other debris, and if so, should be cleaned.
  6, check the universal grinder Hydraulic top head or from the top screw is returned to adjust the gasket is installed correctly and pressed.
  7, the universal grinder is running about 15 minutes to observe the operation.
  8, in the course of their work, such as abnormal noise, the material clogging the bearings or motor overheating, should stop feeding, stop checks, and troubleshooting. Such as the surge in Ammeter reading should reduce the volume of feed or stop feeding until recovery and then gradually feeding. After the end of the grinder work, idling minutes, completely rule out the materials in the machine in order to stop the shredders and fans. In short, the production must be strictly to ensure safety in production, the cotter pin on the pin should always check if excessive wear or fracture of spalling should be replaced immediately. Until everything is normal, can be restarted and run until the speed normal to load.
Related News:
· Innovation, energy saving, environmental protectio  
· Vacuum dryer product performance characteristics a  
· Vacuum dryer used for inspection and debugging wor  
· Difficulties and reasons cannot start mixing machi  
· The correct operation method using vacuum dryer  
· Development advantages and characteristics of dome  
· The difference between the special vacuum dryer an  
· Detailed description of each component characteris  
· The dominant position in the whole vacuum dryer dr  
· Trough type mixer sometimes appear large area leak  
Related Products:
· PGL Spray Drying Granulator
· High speed mixer
· SET series double screw extrusion pelletizer
· VI forced mixer
· Mixing machine W series
· Powder machine ZSJ series vibrating screen
· FZ series of crushing granulator
· Chinese medicine grinder
· DWT series of drier for dehydrated vegetables
· Multi-layer belt dryer

Copyright 2013 Chang Zhou Zhizun Machinery Co.,Ltd All Rights Reserved.Design by Reach.
Tel:86.519-88906508 Fox:86.519-88902679 Add:Jiaoxi Changzhou Jiangsu Pro China P.C:213116