|Universal grinder activities gear and fixed gear see the relative motion, the material being crushed by the teeth impact, friction and material to each other the impact of the combined effects of crush. The machine structure is simple, sturdy, stable operation, crushed well being crushed material can be directly discharged from the grinding chamber, the grain size of the network through the switch to a different aperture sieve to obtain the other machine made of stainless steel. Casing inner wall all by machining to achieve a smooth surface, changing the previous models of the inner wall is rough, the phenomenon of accumulated powder, medicines, food, chemical production more in line with national standards, to meet the requirements of the GMP.
The proper use of feed, universal grinder
l The universal grinder long-term operation, should be fixed in the cement foundation. Frequent changes in the workplace, universal grinder motor to be installed on the base of the angle iron production, universal grinder diesel powered, so that the two power matching, the diesel engine power is slightly larger than the universal grinder power, and between the pulley groove pulley outer end in the same plane.
(2) universal grinder installation after inspection departments fasteners fastening loose if so required to be tighten.
(3) prior to use, check the machine fasteners tighten to check the belt tightness is appropriate, whether the motor shaft and universal grinder shaft parallel.
Universal grinder start, first hand rotation of the rotor, check the tooth, claw hammer and rotor operation is flexible and reliable, whether the shell collision phenomenon, the spindle running direction must comply with the protective hood as shown in the direction of the arrow, otherwise it will damage to the machine, and could cause personal injury. Motor and splintered machine lubrication is good.
Do not replace the pulley, to prevent the excessive speed of the grinding chamber to produce an explosion, or speed too low to affect efficiency.
6 in the crushed material must check the purity, does not allow metal and hard debris mixed in, to avoid to damage the tool or cause burning and other accidents.
7 work and pay attention to the functioning of the universal grinder, feed should be uniform to prevent blocked stuffy car, not a long overload. If it is found that vibration, noise, bearing the body temperature is too high, out spray material and so on, should immediately stop checking, troubleshooting before they can continue to work.
Check universal grinder crush indoor or without metal and other hard debris, otherwise they will bash the tool affect the operation of the machine. Crush Taiwan started to idle 2 to 3 minutes, there is no anomaly after feeding.
Operator not to wear gloves, feeding should be standing on the universal grinder side, to prevent rebound debris wounded face.
10. Stop before stop feeding, if not continue to use the remnants to clear the machine.
11 regular inspection tool with screen is damaged, if damaged, should be replaced immediately.
12. Universal grinder body when using a small vibration, be sure to cover the connection handle tighten to avoid accidents.