|Universal grinder to crush the coup of the oily material:
Viscous oily material has been crushed difficulty. Because the pulverization with the fineness and the temperature increases, the liquid component contained in the material continuously precipitated, causing clogging, poor material, and can only be shut down process. Here to introduce universal grinder to crush the coup of oily materials:
1, first of all, we in the universal grinder inside the device made some modifications to the installation of the blade in the grinding chamber by the rotation of the blades, to increase the amount of wind, but also reduce the temperature, the production has increased significantly.
2 Second, the aggregate bag material adjustments, the use of a larger mesh, the set Liaodai made of breathable material, ventilation rate can be enhanced rapid discharge of heat capacity has also been improved.
Above technical improvements, making the universal grinder is widely used in the field, while increasing the efficiency of the universal grinder.
Universal grinder clogged. The feed speed is too fast, the load increases, causing blockage. Feeding process, it is necessary to pay attention to the ammeter pointer deflection angle, if you exceed the rated current that motor overload, overload for a long time, will burn out the motor. Such a situation should immediately reduce or close the loading door can also change the way you feed to control the feed rate by increasing the feeder. Feeder manual, automatic two users choose the feeders should be based on the actual situation. Due to the high speed universal grinder, big load, and strong load volatility. Therefore, the current the grinder work when the general control about 85% of the rated current. Sluggish or clogged discharge pipe feed too fast, will the universal grinder vent blockage; transportation equipment mismatch will cause a material piping wind weakened or no wind blocked. Detects the failure Qingtong send port change does not match conveying equipment, Adjust the feeding amount, so that the normal operation of equipment. Hammer fragment, aging, mesh hole closed, broken, the crushed material moisture content is too high will cause the universal grinder clogging. Broken hammer and serious aging, should be updated regularly to keep the shredder in good working condition, and periodically check the mesh, pulverized material, moisture content should be less than 14%, thereby enhancing the production efficiency, and universal grinder blockage , and enhance the reliability of the pulverizer working.